Then you can take a look into the pipe, which will usually be dry. Automatic hydrostatic relief valves can be located along the bottom of the main drain pot in the pool. They have a spring loaded mechanization that lets water in automatically when the pool is drained. Hydrostatic pressure increases in proportion to depth measured from the surface because of the increasing weight of fluid exerting downward force from above.
Also known as a Hydro- valve it prevents ground-water pressure from raising the pool or causing movement. The hydrostatic valve prevents this by allowing ground-water from your surrounding yard to flow into the pool and relieve the pressure on the pool structure. Does my pool have a hydrostatic valve? Not all pools have a hydrostatic valve. However most swimming pools do usually have some kind of pressure relief system in place.
Older pools may have a similar version of the valve known as a hydro-plug, which also acts as a pressure relief system. What is the drain at the bottom of swimming pool for?
Pool Drain Systems. We've already seen that the water in a swimming pool needs to circulate through a filtering system, to remove dirt and debris. During normal operation, water flows to the filtering system through two or more main drains at the bottom of the pool and multiple skimmer drains around the top of the pool.
How do you drain a pool with a pump? Go to the back of the filter and unscrew the drain plug. Turn the pump back on and let the water run until it reaches the point where you want to drain the water out. Fill a bucket near the top with pool water and place on the first step of the pool. Mark the water level on the bucket with tape and the water level along the tile line of the pool with tape.
The longer you can leave the bucket in that place undisturbed from swimmers and weather, the more accurate picture we can get of the possible leak. Check the water levels often and log times and results. Be aware, when the system is running, pressure side leaks tend to lose more water. Next, take a look around the yard for severe wet spots, excessive growth of a grass patch or dead grass, as this can be an indication of a leak and its location.
Now that all the preliminary steps have been taken, Leak Detection and Pressure Testing can be performed. First, the inspector will check to see if the pool has a hydrostatic relief valve, and if it is open. A hydrostatic relief valve is located in the deepest part of your pool usually under the main drain cover. The purpose of the hydrostatic relief valve is to relieve the pool of water pressure for those with high water tables. In this case, the hydrostatic relief valve will open allowing the ground water to enter the pool to relieve built up pressure from underneath the pool.
The valve typically does not need any maintenance. However, if the valve has opened then there is a chance that a tiny particle could get stuck in the seal when the valve closes again. The tiniest particle which may not even be seen could allow water to seep out of the pool into the ground, which could be the reason for water loss. Hydro-Static Valve. What is a Hydro-static Valve? Where is the Hydro-valve located? What does a Hydro-static Valve do? Why do swimming pools need a hydro-valve?
Does a hydro-static valve need to be removed when a pool is empty? What are the chances of a swimming pool moving? Can a pool move or crack, lift or shift? Changing Swimming pool water When changing the valve it is also a good opportunity to replace the pool water, Pool water is treated with strong chemicals, and has biological remains such as oils, dead skin and so forth… Pool water can no longer be effectively treated after an estimated years.
Other factors to consider about the chances of a swimming pool moving. Concrete Pools Concrete pools are less likely to shift or raise, because it is a steel reinforced concrete structure that weighs a considerable amount more than any other pool build. How long can a swimming pool stay empty? How often do I need to change the Hydro-static Valve?
How do I remove a hydrostatic valve? Do all swimming pools have a hydro-valve? Hydro plug. Applicable to some older swimming pools. In case the skimmer box is extremely full and is struggling, this may help relieve the pressure that is being applied to the pool pump by allowing an additional flow of water.
0コメント